Direct-lift HR8000 User Manual download pdf (Page 14)

TWO COLUMN 8K FLOOR PLATE LIFT CO7589 IN50014 Rev. D 03/2/2010

STEP 15: Mount the Power Unit on lift as shown.

STEP 16: Mount the Floor Plate as shown below.

STEP 17: Install remaining anchors at this point using directions from page 10.

STEP 18: Install the swing arms on the carriages using the included 1-1/2" diameter pins. Check

for proper engagement of the arm lock – the rack on the lock should fully engage the gear on

the arm. Note you may have to loosen the arm lock bolts to get proper engagement and to

install the arm pins. BE SURE to retighten the lock bolts after the arm pins are installed.

STEP 19: Adjust the carriage cables tension. Adjust each cable to approximately 1/2" side-to-

side play. Check the latch releases to insure the carriage is still sitting on the appropriate latch.

STEP 20: Remove the vent plug from the power unit and fill the reservoir. Use a Ten Weight

(ISO AW32) non-foaming, non-detergent hydraulic fluid (i.e. Texaco HD32 or equal). The unit

will hold approximately twelve quarts of fluid.

STEP 21: Make the Electrical hookup to the power unit; 220V Single Phase. It is

recommended that a 220 Volt, 30 Amp twist lock plug be installed in the power line just ahead of

the power unit. Use wire capable of supporting a 30-amp circuit.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

No comments

Direct-lift HR8000 User Manual Page 14