Direct-lift HR8000 User Manual download pdf (Page 20)

TWO COLUMN 8K FLOOR PLATE LIFT CO7589 IN50014 Rev. D 03/2/2010

Refer to the manufacturer’s specific vehicle lifting points. Some vehicles display these points on a label

inside the right front door lock face or are identified by triangle shape marks on the vehicle’s

undercarriage, reference SAE J2184.

PREVENTIVE MAINTENANCE SCHEDULE

The periodic Preventive Maintenance Schedule given is the suggested minimum requirements

and minimum intervals; accumulated hours or monthly period, which ever comes sooner.

Periodic maintenance is to be performed on a daily, weekly, and yearly basis as given in the

following paragraphs.

WARNING!!

Occupational Safety and Health Administration (OSHA) and the American National

Standards Institute (ANSI) requires users to inspect lifting equipment at the start of every

shift. These and other periodic inspections are the responsibility of the user.

Failure to perform the daily pre-operational check can result in expensive property

damage, lost production time, serious personal injury, and even death. The safety latch

system must be checked and working properly before the lift is put to use.

Failure to heed this warning can result in death or serious injury, or damage to

equipment. If you hear a noise not associated with normal lift operation, or, if there is any

indications of impending lift failure - CEASE OPERATION IMMEDIATELY! - Inspect,

correct and/or replace parts as required.

• Daily Pre-Operation Check (8-Hours)

1. Check safety lock audibly and visually while in operation

2. Check safety latches for free movement and full engagement with rack.

3. Check hydraulic connections, and hoses for leakage.

4. Check chain connections - bends, cracks-and loose links.

5. Check cable connections- bends, cracks-and looseness.

6. Check for frayed cables in both raised and lowered position.

7. Check snap rings at all rollers and sheaves.

8. Check bolts, nuts, and screws and tighten if needed.

9. Check wiring & switches for damage.

10. Keep base plate free of dirt, grease or any other corrosive substances.

11. Check floor for stress cracks near anchor bolts.

12. Check swing arm restraints.

• Weekly Maintenance (every 40-Hours)

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

No comments

Direct-lift HR8000 User Manual Page 20